12v 120w high quality Diaphragm Water oil Pump
- Type:Diaphragm pump
- Suction lift:2m
- Open flow:20L/MIN
- Customization:Customized logo/packaging/Graphic(Min. Order: 1000 Pieces)
- Shipping:Support Express · Sea freight · Land freight · Air freight
1. Connect the water pump with the inlet and outlet pipes, and ensure that the inlet and outlet pipes are closely connected with the pump to prevent empty space from entering, otherwise it will cause low pressure or water leakage; Tip: There is an arrow on the pump cover to indicate the direction of inlet and outlet water, and the arrow direction is outlet water
2. Install the filter at the inlet end, and the density of the filter screen is better than 80 mesh (that is, there are 80 holes in 1cm2)
3. Connect the pump to the power supply, and the power supply parameters must meet the input requirements of the motor
4. Switch on the power supply and start the pump
5. Drain the air from the water pump and pipe for 5-10 seconds. After the water is stable, turn off the power temporarily and connect the water gun (or similar tools).
6. Turn on the power supply to work normally.
